28/09/2026
Here’s a wet room floor I completed last month in Strood.
The existing tiled floor had failed due to poor preparation of the subfloor. The shower former had been installed onto 6mm insulation board 🤯, insulation board laid directly over loose floorboards, with no adhesive to fill the voids and no washers used when fixing it down. This resulted in a huge amount of movement across the floor, causing grout joints to fail and ultimately allowing water to leak through the ceiling below
I stripped the entire floor back and started again: all floorboards removed and replaced with 18mm ply, a new Jackoboard shower former installed onto 18mm ply, fully tanked, 6mm Jackobaord glued and screwed, tiled and grouted with “No Mess” Grouting System - which was an absolute dream to use!
My customers now have a solid, leak free wet room floor 👌🏼
All materials supplied by Pro Tiler Tools